CHANGE_VETOS	(	Qualifier	CLEARALL,
		Qualifier	SMP,
		Qualifier	NOSMP,
		Qualifier	TS2,
		Qualifier	NOTS2,
		Qualifier	HZ50,
		Qualifier	NOHZ50,
		Qualifier	EXT0,
		Qualifier	NOEXT0,
		Qualifier	EXT1,
		Qualifier	NOEXT1,
		Qualifier	EXT2,
		Qualifier	NOEXT2,
		Qualifier	EXT3,
		Qualifier	NOEXT3
	)

Change vetos as part of a block change operation.

Block change operations are enclosed by CHANGE_START and CHANGE_FINISH commands. The default behaviour is to leave the veto setting unchanged if it is not specified, so you need to explicitly use e.g. /NOSMP to always disable the SMP veto

Parameters:

`[in]`	SMP	enable SMP veto
`[in]`	NOSMP	disable SMP veto
`[in]`	TS2	enable TS2 pulse veto
`[in]`	NOTS2	disable TS2 pulse veto
`[in]`	HZ50	enable ISIS not at 50 Hz veto
`[in]`	NOHZ50	disable ISIS not at 50 Hz veto
`[in]`	SMP	enable SMP veto
`[in]`	NOSMP	disable SMP veto
`[in]`	EXT0	enable external veto 0
`[in]`	NOEXT0	disable external veto 0
`[in]`	EXT1	enable external veto 1
`[in]`	NOEXT1	disable external veto 1
`[in]`	EXT2	enable external veto 2
`[in]`	NOEXT2	disable external veto 2
`[in]`	EXT3	enable external veto 3
`[in]`	NOEXT3	disable external veto 3
`[in]`	CLEARALL	clear all vetos first (can be used in combination with others)

Precondition:: A previous CHANGE_START command been issued